2003 dodge ram 2500 crankshaft position sensor location

pics would be great....i know its a lot to ask haha

It's real easy to replace. Search for Rokktech and I'm sure someone will have posted pics of their install...

dealer told me there were two sensors.....that true?

Yes, there is a crankshaft sensor and a camshaft sensor. They are the same part. As stated above the cranshaft sensor is simple to swap. The camshaft sensor is fairly easy as well, but hard to get your hands in there.

Pete

Crankshaft is simple, the camshaft is a .

The crankshaft sensor is located at the lower left hand side of the crank pulley.

well i got the crankshaft sensor switched out an now it starts up fine...the check engine light is still on but i have not cleared the code yet...for thoes of you would have yet to change this out here is a pic of where the crankshaft sensor is located...looking from the bottom of the truck. the camshaft is located about 6" above this one next to the cp3 an is a lot harder to get to. hope this helps

Where is the best place to buy both of these?I would like to have them in the truck JIC....Parts houses?Ebay?

the tensioner pulley went bad on my o6 dodge ate the belt up and broke 2 teeth off of the plastic piece after replacing belt a day later the truck has a miss on and off would those teeth missing cause the miss

Where is the best place to buy both of these?I would like to have them in the truck JIC....Parts houses?Ebay?

Anybody bought these before or had to replace them??

Where is the best place to buy both of these?I would like to have them in the truck JIC....Parts houses?Ebay?

I bought mine from Wyckoff Auto Parts: http://www.partswebsite.com/wyckoffmopar/index.php?type=parts&start=1&home=1

I like them for just about all of my OEM replacement parts as their prices are good and they ship cheap and quick. They also verify the parts fitment if you supply your VIN in the order.

I bought a replacement crank sensor when I started getting the error code almost daily, but when I pulled my sensor to replace it I found it was covered in grease and oil, so I just cleaned it up and put it back in. But, it is nice to know I have the replacement on hand if I should need it in a pinch.

i also just got a cps error code, so i went out and got both the crank and cam sensors and did the cam sensor, when i pulled the crank sensor out i saw it was covered with oil/grease cleaned er up nice put er back in and alls good. the picture posted in this thread did me wonders. cause for awhile there i was struggling to find them sensors, so thanks alot guys

I replaced my crankshaft position sensor about 10 months ago and now it is throwing the code again, yesterday I pulled it and this time it is covered in oil. (FYI)The one I replaced before was dry. Does anyone know where the oil would be coming from? I cleaned it and put it back in, but the check engine light is still on.

2000 2500 4wd Automatic

Just bought my 2500 from the original owner (one of my best friends) cheap because the tranny is hurt the brake lines were rusted out as in would not hold fluid and it is rusty...put in all new brake lines and everything brake related and it died after driving it for 8 miles and won't start scanning it today hoping it is not the pump...already dumped over a grand in parts-all the brakes, batteries, fuel sending unit etc and want to drive this thing!