When autocomplete results are available use up and down arrows to review and enter to select. Touch device users, explore by touch or with swipe gestures. Show
Kenmore 106. Series Water Filter Replacement Instructions Kenmore 253. Series Water Filter Replacement Instructions Kenmore 363. Series Water Filter Replacement Instructions Ken…Kenmore/Coldspot refrigerator water filters - Learn how to remove and replace your Kenmore water filter yourself at WaterFilterMart.
Kenmore/Coldspot refrigerator water filters - Learn how to remove and replace your Kenmore water filter yourself at WaterFilterMart.3. Take the new cartridge out of its packaging and remove protective cover from o-rings. The base grille water filter stains light The vi/ater fiiter status iight wili help you know when to change refrigerator compartment. The iight wiil change from green to yellow. This telis you that it is almost time to change the water filter cartridge (90% of the fiiter iife has been used), it is recommended that you repiace the base griile water filter red OR water fiow to your water dispenser or ice maker decreases noticeabiy. (See “Changing a base griiie water fiiter cartridge”
NOTE: Do not use with water that is microbiologically unsafe 1. Ststus Light 2. Light Switch After changing the water fiiter cartridge, reset the water filter status light by pressing the light switch 5 times within 10 seconds. The status iight wiil change from
red to green when the Non-indicator water filter (on some models) If your refrigerator does not have the water filter status light, you Changing a base grille water filter cartridge The base grille water filter is located below the freezer compartment door. 1. Locate the water fiiter cartridge cap in the front base grille below the freezer compartment door. Rotate the cap fiiter cartridge out through the base grille. NOTE: There will be water in the cartridge. Some spilling may occur. 2. Remove the cartridge cap by sliding it off the end of the old 4. 5. Slide the cartridge cap onto the new cartridge as shown With cartridge cap in the vertical position, push the new filter 6 . Flush the water system by dispensing and discarding 2 to 3 gallons (8 to 12 liters) or approximately 6 to 7 minutes help clear air from the lines. Additional flushing may be required in some households. NOTE: As air is cleared from the system, water may spurt out of the dispenser. Using the dispenser without the water filter You can run the dispenser without a water filter cartridge. Your
1. Remove the base grille water filter cartridge (See “Changing a base grille water filter cartridge” earlier in this section.) Then slide the cartridge cap off the end of the filter cartridge. DO NOT DISCARD THE CAP. 2. With the cartridge cap in the vertical position, insert the cap into the base grille until it stops. 3. Rotate the cartridge cap to a horizontal position as shown in NOTE: The cartridge cap may not be even with the base grille. 12 |